ABOVE: T 337 at Sth Dynon loco, 1984. The yellow painted handrails were an early 80s addition.
The T's were VR's most numerous diesel loco class and arrived on the system over a 13 year period (1955 to 1968). Purchased as VR's primary branchline loco, the T's could be found literally all over the system. VR officials would later admit that they purchased too many T's as the branches were starting to close just as the last T's were being delivered. In my opinion the last 2 orders (20 locos) should never have placed and the money used on X class instead. Apart from holding down their branchline assignments they were also found in mainline service usually behind a bigger loco, they also could be found running shorter distance passenger trains (Seymour, Ballarat, Kyneton, Werribee/Geelong etc. ) as well as most branchline passenger trains, (Daylesford, Cobram, Bairnsdale, Yarram, Swan Hill, Queenscliff etc.)
ABOVE & BELOW: As built photos of T 320, note the short end handrails which were modified very early in their lives.
ABOVE & BELOW: T 320 at Port Melbourne in "as built" condition August 20 1955, (the month it was delivered). The photo above clearly shows the drivers controls on what would become the firemans side.
ABOVE: T 322 at Sth Dynon loco, Oct 10 1981. BELOW: T 322 on its delivery run in NSW, the loco was on standard gauge and its Broad Gauge bogies were on the flat wagon behind the loco.
ABOVE: T 330 at Sth Dynon loco, Oct 10 1981. T 330 was converted into P 14.
ABOVE: For many years T 333 carried this unique cowcatcher, photo at Newport 1978. BELOW: This photo of T 333 was taken Aug 1983 after a repaint and the unique cowcatcher has been replaced.
ABOVE: T 342 at Sth Dynon towards the end of its career showing the chopped valance, photo 1988
ABOVE: T 343 at Sth Dynon, July 1964, note the stovepipe exhaust, photo courtesy PROV.
The first T's were quite distinctive with their flat roofline. This was a standard EMD export design and were basically "off the shelf" The bogie mounted sandboxes were also distinctive. The flat roofline made for a very cramped cab and only the shortest crewmember did not have to duck their head when inside. They were however the best riding of all of the T class due, presumably, to their lower centre of gravity and longer wheelbase. Of all the T's the first series were the least likely to wheelslip when lugging at low speeds. T's 320 to 333 were delivered with their controls on what became the firemans side. The controls were relocated in early 1966.
T 320 and 321, as delivered the yellow stripe along the side was much narrower as can be seen in the photos of T 320. Exhausts changed over the years as well. In the early 80's several T's had their skirt above the fuel tank area removed for maintenence ease as shown on T 342, T's known to have chopped skirts include 321, 333, 342, 343, 345. Several got yellow handrails and 321 and 345 got distinctive aluminium side cab windows. In 1986 T 345 was electrically modified for hump working along with T 413. T 320 - T 325 kept their fabricated bogies for their entire lives which made them different from the rest of the 1st series T's.
In 1984 13 first series T's were sent to Clyde for a complete rebuild, after rebuilding they became the P class numbered P 11 to P 23.
Road # | Serial # |
In service
|
Withdrawn | Service life | Disposition | Color schemes | Notes |
T 320 | 55-63 |
3/8/1955
|
5/1986 | 1,681,945 miles | to SRHC | vrb | |
T 321 | 55-65 |
23/8/1955
|
5/1986 | 1,594,102 miles | scrapped. | vrb | Beclawat windows, chopped valance. 1st T scrapped |
T 322 | 55-67 |
12/9/1955
|
5/1986 | 1,603,360 miles | to Bob White Electrix | vrb | |
T 323 | 55-68 |
26/9/1955
|
5/1986 | 1,672,910 miles | to Bob White Electrix | vrb | |
T 324 | 55-73 |
30/11/1955
|
6/1986 | 1,546,157 miles | to Bob White Electrix | vrb | |
T 325 | 55-75 |
11/12/1955
|
5/1986 | 1,626,196 miles | scrapped May 1989 * | vrb | Scrapped 5/1989 |
T 326 | 55-76 |
29/5/1956
|
5/1984 | 1,494,756 miles | conv. to P 23 | vrb | |
T 327 | 55-78 |
29/5/1956
|
12/1984 | conv. to P 17 | vrb | ||
T 328 | 56-80 |
19/6/1956
|
9/1985 | 1,456,909 miles | conv. to P 22 | vrb | |
T 329 | 56-82 |
19/6/1956
|
6/1984 | conv. to P 12 | vrb | ||
T 330 | 56-85 |
3/7/1956
|
8/1984 | conv. to P 14 | vrb | ||
T 331 | 56-98 |
3/7/1956
|
3/1985 | conv. to P 19 | vrb | ||
T 332 | 56-99 |
23/7/1956
|
11/1984 | conv. to P 16 | vrb | ||
T 333 | 56-102 |
23/7/1956
|
7/1986 | 1,614,210 miles | to C&MRPS Vic Goldfields Rwy. | vrb | |
T 334 | 56-105 |
20/8/1956
|
12/1989 | 1,644,874 miles | to Mornington Pres. | vrb - "ozride" vrb | |
T 335 | 56-106 |
20/8/1956
|
8/1986 | 1,658,551 miles | scrapped May 1989 * | vrb | Scrapped 5/1989 |
T 336 | 56-110 |
10/9/1956
|
5/1984 | conv. to P 11 | vrb | ||
T 337 | 56-112 |
24/9/1956
|
5/1985 | conv. to P 20 | vrb | ||
T 338 | 56-114 |
24/9/1956
|
6/1985 | conv. to P 21 | vrb | ||
T 339 | 56-115 |
8/10/1956
|
2/1984 | conv. to P 18 | vrb | ||
T 340 | 56-119 |
31/10/1956
|
7/1984 | conv. to P 13 | vrb | ||
T 341 | 56-120 |
5/11/1956
|
5/1986 | 1,576,095 miles | to Yarra Valley Rwy | vrb | |
T 342 | 56-123 |
12/11/1956
|
9/1989 | 1,629,992 miles | to Steamrail | vrb -apm yellow | Chopped valance |
T 343 | 56-126 |
10/12/1956
|
6/1986 | 1,523,154 miles | to Bob White Electrix | vrb | |
T 344 | 56-127 |
10/12/1956
|
10/1984 | conv. to P 15 | vrb | ||
T 345 | 56-128 |
24/12/1956
|
12/1987 | 1,592,865 miles | vrb | Beclawat windows | |
T 346 | 56-129 | 24/12/1956 | 5/1986 | 1,580,786 miles | sold to Steel & Alloy, scrapped May 1989 * | vrb | Scrapped 5/1989 |
ABOVE: D 1 in service for its original owner at Fyansford April 12 1964. Photo courtesy Des Jowett.
T413 was purchased second hand from the Australian Portland Cement quarry which had a railway within its quarry. It was numbered D 1 by its original owner. Mechanically identical to the first T class order it was the only T fitted with dynamic brakes. From the time VR purchased it until the Cudgewa line closed, (late 70's) it was the main power on this branchline where its dynamic brake was put to good use.
ABOVE: T 413 in about 1985 at Sth Dynoon loco, clearly showing the cut away valance that enabled easier servicing.
ABOVE: D 1 as delivered to the VR after it being purchased from the Australian Portland Cement company. The loco was built alongside VRs first series T's and presumably to save money the Cement company had it painted in the same scheme as the VR Ts with the only change being the logo. official VR photo. BELOW: Undergoing modifications at Newport to enable it to operate on the VR, the cowcatcher, steps and coupler pocket had to be re-worked. photo courtesy David Langley.